 |
| One of the most important factors in the operation of your
RO DI system is pressure. Running an RO system at too little pressure causes
under production and over waste. Not to mention the fact that the membrane
is unable to operate correctly and the output water will be higher in TDS.
You use a TDS meter to test the quality of the output water but do you know
the pressure your system is running under? You could be throwing away DI
after DI simply because your RO is not working as well as it should. This
is the next step in knowing exactly what is going on with your system! Installation
is a snap with all Quick connect fittings included. With this purchase you
will receive all the fittings needed to install your new gauge and a 500
foot roll of teflon tape...Just incase :) |
 |
| Gauge reads up to one hundred PSI and has a back/center 1/4
inch male thread inlet. All fittings are included with this purchase to
install the valve either to a panel or loosely. |
 |
1) 100 PSI RO Pressure Gauge
1) 1/4 tube by 1/4 female thread stem
1) 1/4x1/4x1/4 Y style T fitting
1) 500 foot roll of teflon tape |
more...
